• With the rapid development of market economy, all walks of life are improving the production process and quality of products, galvanized iron wire industry is of course no exception. However, because of the different types of galvanized iron wire, its characteristics and production technology are also different. Galvanized wire selection of high quality low carbon steel rod processing, is the selection of high quality low carbon steel.


  • Post time: 05-01-23
  • The patented technology is used to regularly put zinc blocks into the plating aid pool, so that the bivalent iron in the plating aid becomes trivalent iron, and plays an important measure to stabilize the PH value within a numerical range, and also facilitate the filter to filter out the trivalent iron ions in the plating aid; The trivalent iron ion is controlled between 0.3 and 1.0g/L; When hydrogen is not released in the plating aid, the zinc block is continued. It is an effective measure to reduce zinc slag, improve the fluidity of zinc liquid and reduce the thickness of zinc layer to give full play to the function of plating aid filter.

  • Twisted

  • Galvanized

  • Zinc pot workers should be determined to do duty and responsibility. Do not leave the post without leave, always observe the change of hot plating wire galvanized layer, and according to the analysis results, master the asbestos block gap friction, how long it takes to press, replace the pressing face; Adjust the working face; Until all four sides of the asbestos block are used up, maintenance workers will continue to use the block after repair when necessary to reduce the consumption of asbestos block.

  • Before wall plastering, the wall column is connected to the gap construction wire mesh, which can play a certain strengthening and heat preservation effect. The mesh is hung on the interface surface of different grassroots, and the length of each side should meet the requirements of 100mm, so as to prevent shrinkage and cracking caused by different grassroots. Mesh wire diameter can also determine the effect and efficiency of construction, mesh fine laid up convenient soft, high construction efficiency; Of national standard can assure quality, but laid respect is inferior to fine construction fast.

  • galvanized

  • All can do spring can be called spring steel wire, and high carbon is the highest carbon content. Features: WITH high strength and hardness, high elastic limit and fatigue limit (especially notched fatigue limit), cutting function is OK, but welding function and cold plastic deformation ability is poor.

  • Plastic spraying is also we often talk about electrostatic powder spraying, it is the use of electrostatic generator to make plastic powder charged, adsorption on the surface of the iron plate, and then through 180~220 DEG C baking, so that the powder melting adhesion on the metal surface, plastic spraying products are used for indoor use of the box, paint film flat or matte effect. Spray powder mainly acrylic powder, polyester powder, etc.

  • 2.25*2.25mm 10 meters per kilogram
  • Like highway guardrail, silk screen can be used, in production can also be according to the needs of customers, such as the need for different diameters of galvanized wire products, in the material selection and coating to carry out reasonable control. Our industry is a low carbon steel with good quality as raw material, and then through the pulling out, galvanized process, thus producing good galvanized iron wire.

  • Steel mesh benefits: Compared with traditional handmade steel mesh, steel mesh has better elasticity and even spacing. When pouring concrete, the steel mesh is not easy to bend, and the thickness of concrete protective layer is easy to control and even. In bridge deck surfacing, measure the protective layer of steel mesh. The pass rate is 95 percent.


  • Post time: 08-02-23
  • The last is the size of the barbed rope or blade barbed rope. The commonly used size is good, especially for some special-shaped products, which need to be mentioned repeatedly in the production process of the barbed rope factory to avoid unnecessary losses.

  • Two, cold galvanized wire production process of galvanized. Galvanizing is the core process in the production of cold galvanized wire, mainly by soaking the steel wire in a molten zinc solution to form a zinc layer on its surface.
  • Bird

  • Galvanized iron wire has tolerance and elasticity, the amount of zinc can reach 300 g/square meter. It has the characteristics of thick galvanized layer and strong corrosion resistance. Widely used in construction, handicrafts, wire mesh, highway guardrail, commodity packaging and ordinary civilian and other fields.

  • 3. When you travel with your dog, it will not cause anxiety to some friends because the dog is scattered in the car, or it will affect safe driving and bring risks.
  • The diameter of welded mesh wire for external walls is generally 2.2-ф4.0, and the mesh is generally 25-50.
  • The wire diameter of raw materials used in different types of barbed rope is also very different, but in the production and processing process of barbed rope need to know the amount of use.

  • The price of galvanized iron wire performance is the key to win, galvanized wire only with good performance, in order to win the market, in order to obtain customer praise. In galvanized wire, the main function of carbon in increasing hardness, less is less easy to rust, the main function of chromium is acid and alkali resistance; Nickel’s main function is high temperature resistance, acid and alkali resistance and conductive use; The main function of iron is magnetic conductivity; The main functions of titanium are low density, high hardness and strong corrosion resistance. The main function of copper is magnetic and electrical conductivity. Different chemical components have different functions, which together form the characteristics of galvanized wire.

  • In strict accordance with the multi-pass small compression rate drawing, the total compression rate is 96.48%, reducing the scraping of zinc layer. The whole wire drawing die is made of tungsten steel die and polycrystalline die. The Angle of the working cone of the wire drawing die is 12° ~ 16°, and the length of the sizing belt is 0.15 of the diameter of the wire, so as to ensure that the deformation of the zinc layer is basically synchronous with the steel wire substrate.

  • steel

  • Pet

  • The service condition and service life of electro galvanized iron wire or component are closely related to the thickness of electroplated coating. The more strict the conditions of use and the longer the service life, the thicker the layer of galvanized iron wire required. Different products, according to the specific environment (temperature, humidity, rainfall, atmospheric composition, etc.) to determine the expected service life of the coating thickness, blind thickening will cause all kinds of waste. But if the thickness is insufficient, it will not reach the expected service life requirements. Different manufacturers, according to their own equipment conditions, in the case of determining the plating, the first preparation of a more complete and reasonable process flow, clear plating parameters, control plating solution concentration, standard operation.