Current location:drainage mat waterproofing >>Text

drainage mat waterproofing

Hebei Qiuzhuo door bottom noise seal9People have read

Introduction...



Popular articles


  • Post time: 06-04-23
  • barbed

  • After annealing, the extension rate of galvanized wire is increased, making the product more soft and increasing the scope of application of galvanized wire. After electric galvanized hot galvanized, electroplated copper and other widely used screen production. Building reinforcement binding with galvanized wire mesh braided with the first after plating, plating and other methods, after treatment of galvanized wire mesh or steel wire mesh, has good corrosion resistance, oxidation resistance characteristics, can be used in construction, petroleum, chemical, aquaculture, garden protection, food processing and other industries reinforcement, protection and heat preservation.

  • Stainless

  • Now the production of stainless steel blade barbed rope unless it is specially customized model, under normal circumstances is the use of 22mm knife length mold production, that is, we usually say BTO-22 type. It is not necessarily such a specification from 11mm to 65mm are specifications. Unless the customer insists on the length of the customized requirements, the barbed rope manufacturers produce is BTO-22 stainless steel blade barbed rope.

  • 1, barbed rope protection net center line along the road within the land boundary 20 to 50 cm set.
  • In addition, galvanized silk manufacturers can be required to passivation treatment after zinc immersion, after passivation treatment of zinc has a better anti-discoloration effect, can effectively extend the time of discoloration, the combination of the two, discoloration should be able to solve.

  • galvanized


  • Post time: 13-02-23

  • Post time: 02-06-23
  • There are many production links of blade barbed rope, and the finished product can only be produced after several times of production. Roughly, there are four or five links.

  • Aquaculture

  • hot

  • For the specification of galvanized wire, the galvanized wire produced by our factory can range from No.8 to No.22, which refers to the BWG standard, that is, from about 4mm to 0.7mm, which can basically cover the type required by customers. As for the raw material of galvanized wire, normally, we use Q195 mild steel, and some factories will also use SAE1006 or SAE1008. The following is the zinc coating, for galvanized wire, this thing is more important, the general zinc coating is about 50g/m2 to 80g/m2, some customers need high zinc galvanized wire, zinc coating can reach 200g/m2 to 360g/m2. The tensile strength of galvanized wire is usually 350n/m2 to 800n/m2. Then there is the packaging specification of galvanized wire. The specifications of small rolls of galvanized wire are 50kg/ roll, 100kg/ roll and 200kg/ roll. Of course, there are large rolls of galvanized silk, the weight can reach 300kg/ roll or 800kg/ roll.

  • As we all know, even if it is the same kind of steel wire, because of the steel making process, wire drawing process and equipment are not the same, so the quality of steel wire production is not the same. Due to the different mechanical properties of steel wire itself, flattening process and equipment, the width and elongation of steel wire in the flattening process have different effects. Therefore, in the selection of wire diameter, the following three factors should be considered:


  • Post time: 19-05-23
  • galvanized

  • barbed

  • 3, pay attention to the width of the cage seam


  • Post time: 01-11-22
  • galvanized

  • The surface of alluvium before hot dip galvanizing of orchard special electric galvanized shaft wire can partially remove the surface film layer, surface impurity and other shortcomings according to the basic technology to find and solve; Excessive foam is caused by soap and soapable surface active substances such as human fat into the tank. A moderate rate of foam production would be fine. There are many fine homogeneous particles in the tank, can stabilize the foam layer, with activated carbon mat to remove surface active substances. Or make the bubble unstable according to overworry, these are all reasonable countermeasures; Other strategies should also be used to reduce the amount of surface-active substances introduced. The introduction of organic matter can make the electroplating process speed drop sharply. Although the secret recipe of organic chemistry is beneficial to the high accumulation rate, the thickness of the coating can not meet the requirements after the organic matter is brought in, so the activated carbon can be used to solve the tank.