• chicken

  • As we all know, stainless steel barbed rope is installed in the outdoor, after a long time of exposure to the sun is easy to rust, once rust service life will end. So want to extend the service life of stainless steel barbed rope must prevent rust. In general, in order to prevent rust, we will choose to spray stainless steel barbed rope.
  • There is no adhesion test of powder spraying or fluorocarbon spraying on packaged galvanized wire, but there are two points for reference: first, in sealed or air-free environment, non-metallic volatiles can corrode zinc coating; Second, zinc at higher than 230 degrees (c) will cause the matrix metal brittle. And powder spraying and fluorocarbon spraying are to be baked at a higher temperature and in a sealed environment, causing rapid corrosion of zinc, resulting in loose corrosion film resulting in coating adhesion decline, and even lead to (matrix) steel wire brittle situation may exist.

  • In use, it can be well used to control its soft and hard degree in the annealing process, mainly used in the construction industry as a binding wire and binding line. Of course, its use is not limited to arts and crafts, but also widely used in the construction industry. Earlier woven lanterns were made of iron wire with appropriate candles placed inside. People hung them in front of their doors and looked very beautiful at night.
  • 3.Packaging: moisture-proof paper, woven bag, other packaging can be packed according to customer requirements

  • The cage can be placed in a corner so that the bird can see what is going on around it and can retreat to the back of the cage without fear of being approached. The height of the cage from the ground is also important and is ideal slightly below eye level.
  • Because of the high carbon content, simple cracks occur during water quenching, so double liquid quenching (water quenching + oil cooling) is mostly used, and oil quenching is mostly used for small cross section parts. This type of steel is generally used after quenching by medium temperature tempering or normalizing or in the surface quenching state. Mainly used for manufacturing spring and wear-resistant parts.


  • Post time: 30-01-23
  • Aquaculture

  • D, coating adhesion; The zinc layer of the plating parts should be firmly combined with the base metal with sufficient adhesion strength, and will not fall off or bulge after the hammer test.

  • barbed

  • Heavy hexagonal net, also known as large size hexagonal net, or gabion mesh, made of steel wire by twisting mesh machine. This product is very versatile. Can be used for slope support, foundation pit support, mountain rock surface hanging net shotcrete, slope planting (greening), railway highway isolation barrier, it can also be made of stone cage, stone pad, for rivers, DAMS and seawall anti-erosion protection and reservoirs, river interception with stone cage.

  • The derusting steel parts are immersed in the melted zinc liquid at about 500℃, so that the surface of the steel member is attached with zinc layer, so as to achieve the purpose of anti-corrosion. The surface of galvanized wire coating can see whether the quality of galvanized wire is good or not. If the strength of zinc attached to the wire is very poor, then this galvanized wire do not buy, because this galvanized wire must be poor galvanized wire.

  •  


  • Post time: 02-06-23
  • Coping methods we also have: 1, gouging, the straight wire rolled into a wavy shape, but still not enough to raise chickens with mesh can only be large enough to extend the beak can not feed! 2, is the electric welding net, with the current to wire spot welding together, mesh is not limited.

  • Galvanized hexagonal net uses: building wall fixing, heat preservation, heat insulation; Power plant piping, boiler insulation; Anti-freezing, residential protection, landscaping protection; Raise chickens and ducks, isolate chicken and duck houses, protect poultry; Protect and support seawalls, hillsides, roads, Bridges and other water and wood works.

  • First, cold galvanized wire production process before treatment. Before galvanizing, a series of pre-treatment work on the steel wire is required, mainly including pickling, dissolution and brine or alkali washing.

  • Post time: 06-05-23

  • Post time: 13-04-23
  • The construction of inner wall and outer wall steel wire mesh can effectively solve the wall cracks, falling off, empty drum phenomenon. Hot dip galvanized steel wire mesh material requirements: net surface leveling, width and length to meet the project required standards, welding process, weight, zinc, etc., with more production and operation, detection certificate is complete.

  • Second, word of mouth selection
  • Custom is made of low carbon steel silk woven, mesh structure he has the characteristics of corrosion resistance, high strength and ductility. Steel wire diameter up to 2.0mm-4.0mm, steel wire appearance is usually selected hot dip galvanized maintenance, galvanized maintenance layer thickness can be made according to customer needs, galvanized maximum can reach 300g/.

  • One is to do a good job of galvanized wire packaging, to avoid bumping, to ensure the integrity of the zinc layer;

  • In GENERAL, THE HARDNESS OF A METAL IS OFTEN CONSIDERED AS THE RESISTANCE OF a MATERIAL TO COMPRESSION PLASTIC deformation, scratches, wear, or cutting. In the adjustment of zinc dip distance of galvanized wire, keep the original speed unchanged, according to the time of zinc dip, wire diameter, and then estimate the zinc dip distance. By adjusting the zinc dipping distance, the zinc dipping time of various specifications of steel wire is shortened by 5s on average compared with that before debugging, so that the zinc consumption is reduced, the zinc consumption per ton of steel wire is reduced from the original 61kg to 59.4kg.