Popular articles

Latest articles


  • Post time: 27-03-23

  • Post time: 28-07-22
  • Zinc coating on steel and ferrous metal plays an anodic role, it is commonly used for those parts subjected to atmospheric or water action, but zinc coating only when the water temperature below 60℃, the anode properties. When the temperature is higher, the potential changes and the zinc to iron becomes the cathode. Therefore, for parts subjected to hot water (such as steam boilers), the zinc skeleton must be approximately 70 microns thick and void free. For parts subjected to low or normal temperature or atmospheric action, zinc coating without pinholes is not necessary.
  • The above is to extend the service life of stainless steel barbed rope method, mainly to spray and galvanized.

  • Steel wire mesh is finished by fine welding of active welding equipment. The material can be divided into cold wire drawing, hot galvanizing, cold galvanizing, dip plastic and so on. To be used for bridge reinforcement, bridge deck pavement, building reinforcement and so on.

  • Galvanized

  • Zinc pot workers should be determined to do duty and responsibility. Do not leave the post without leave, always observe the change of hot plating wire galvanized layer, and according to the analysis results, master the asbestos block gap friction, how long it takes to press, replace the pressing face; Adjust the working face; Until all four faces of the asbestos block are used up, maintenance workers can continue to use the asbestos block after repair when necessary to reduce the consumption of asbestos block.
  • steel

  • With a large pickpocket used for steel wire, into the zinc liquid before the surface of the zinc ash stirring; Use a small outlet for galvanized steel wire; Zinc pot steel wire outlet in 30 minutes, with pickpockets back and forth, until the large, floating zinc residue into brown, real zinc ash, zinc ash surface. The extracted zinc ash should be brown yellow real zinc ash, zinc surface, effectively reduce zinc consumption. This is one of the measures to reduce zinc consumption, but it is also a real problem, which has not been solved for many years.

  • Different hot dip galvanizing process is divided into two categories of annealing outside the line and annealing in the line, hot dip galvanizing is in the hot melt zinc liquid immersion plating, production speed, thick but uneven coating, the market allows Z low thickness of 45 microns, Z high can reach more than 300 microns. It is dark in color, consumes more zinc metal, forms infiltration layer with base metal, and has good corrosion resistance. Hot dip galvanizing can be maintained for decades in outdoor environment.

  • 5. It prevents your dog’s fear from causing chaos or other problems.
  • Electric welding net welding after galvanized is after the completion of the welding and then cold galvanized or hot galvanized; After the first galvanized welding is to change the wire welding mesh, welding can be seen after the completion of the welding spot; The two processes are different prices are also very different, the cost of the first plating after welding is low, the surface is smooth, and the cost of the first welding after plating is higher, not easy to rust.


  • Post time: 22-02-23
  • Spray powder mainly acrylic powder, polyester powder and so on. Dipping is a kind of plastic coating process, that is, the plastic coating on the matrix, generally metal, such as: daily use of clothes hangers, pliers handles, scissors on the rubber sleeve, various handrails, etc. Plastic immersion is to heat the metal to spray plastic powder evenly on the metal to form a plastic film, or heat immersion liquid into the metal to cool it and then plastic coating on the metal surface.

  • Cold galvanized wire refers to a process in which ordinary steel wire is treated by cold galvanized and a zinc layer is attached to its surface. Cold galvanized wire has the advantages of anti-corrosion and anti-wear, and is widely used in construction, machinery, automobile, electronics and other industries. The following will introduce the production process and flow of cold galvanized wire.

  • 2. Dissolution treatment: Put the pickling steel wire into the dissolution tank, and dissolve the zinc powder with the bath liquid by heating, and the dissolved zinc liquid will adhere to the surface of the steel wire.


  • Post time: 18-05-23
  • barbed

  • Barbed wire is used to make barbed wire, in part, to prevent livestock theft, because the surface is covered with sharp spikes that make it very difficult to penetrate through the barbed wire. On the other hand, it is because livestock generally have the habit of charging, and the barbed rope is used to circle, which makes livestock dare not rush to charge the barbed rope, thus saving the user’s use cost.

  • There are 7 to 8 circles between the two thorns of the front and back twist barbed wire, while the ordinary barbed wire only has 3 and a half circles, which is neat and beautiful.

  • Post time: 10-05-23
  • There are many kinds of specifications for crack resistant welding mesh used in the construction industry. The commonly used specifications are as follows:


  • Post time: 30-06-22
  • galvanized

  • In order to adapt to the living habits of different birds, ornamental cages can be roughly divided into two types of bird cages, namely cereal and insectivorous cages. Cereal bird cage with canary cage, yellow bird cage, wenbird cage, bird cage, hydrangea cage, insect-eating bird cage with thrush cage, chin cage, myna cage and so on.

  • Decorative hook mesh size width generally does not span 2 meters. Generally, the length does not span 4m. It is difficult for workers to span 2m, and it is not good for galvanizing and plating. It can reach 6 meters in length, but it won’t cross 6 meters. Generally across 4 meters after the price will be significantly higher.
  • 2. The cleaning agent used for cleaning should have no effect on the binding force of the coating and no corrosion on the matrix.

  • Compared with hot-dip galvanized barbed rope, it is much better in the circle of mountains and forest protection. Because it can choose several colors on its appearance, different sites have different colors, which is both beautiful and practical, so as to facilitate the growth of natural plants and gradually recover the original ecological environment.


  • Post time: 23-06-22
  • In order to pack and bind galvanized wire in the surface of the sedimentary layer to local removal of surface film, surface inclusion and other defects can be found and treated by conventional technology; Excess foam is formed when soap and surfactants such as saponified fats are brought into the tank. Moderate rates of foam formation may be harmless. Small, homogeneous particles of large denier present in the bath can stabilize the foam layer. Use activated carbon mat to remove surface active substance. Or through filtration to make the foam is not too stable, which are effective measures; Other measures should also be taken to reduce the amount of surfactant introduced. The electroplating speed can be obviously reduced by the addition of organic matter. Although chemical formulations facilitate high deposition rates, the deposition of organic matter does not meet the requirements of coating thickness, so activated carbon can be used to treat the bath.

  • Steel mesh galvanized: galvanized refers to the surface of metal, alloy or other materials coated with a layer of zinc to play a beautiful, rust prevention and other surface disposal technology. Now the first choice of method is hot dip galvanized, galvanized solution has cyanide bath and cyanide-free bath two categories. Cyanide bath bisects micro cyanide, low cyanide, medium cyanide, and high cyanide.

  • 2.25*2.25mm 10 meters per kilogram
  • Galvanized iron wire is very common in practical application, some people think that galvanized iron wire will not rust, in fact, it is not. Metal corrosion is caused by the chemical or electrochemical action of the surrounding medium. According to different media, it is divided into atmospheric corrosion, soil corrosion, seawater corrosion, bacterial corrosion and so on. Atmospheric corrosion is more common, because metal products in the process of processing, transportation and storage, when in contact with the atmosphere, there are always atmospheric corrosion conditions.

  • Sodium and magnesium contain less combustible impurities, and when extinguished, they simply glow. Galvanizing belongs to the electrochemical processing process which is widely used on the surface of steel. So it is, first of all, because zinc coating (especially after supplementary processing, such as chromate treatment and phosphating) resistance to atmosphere and water is more stable, and the galvanized process itself this is cheaper and simple.