Links


  • Post time: 06-05-23
  • Large roll galvanized wire can be divided into hot-dip galvanized wire and cold galvanized wire, the difference between the two lies in the way of zinc and the amount of zinc. Hot dip galvanizing is to soak steel wire in melted zinc liquid, hot dip galvanizing zinc fast, zinc layer thick rust prevention performance is very good, but the zinc is not uniform, and the surface is dark, the life of hot dip galvanizing can reach 20 years.


  • Post time: 07-03-23
  • 1, barbed rope protection net center line along the road within the land boundary 20 to 50 cm set.
  • In white iron, its carbon and iron phase into iron carbide, crack white, extremely strong and brittle, for the malleable steel material. Alloy grades are made up of various alloying elements with different compositions and structures. Because the alloy element in the iron can make the copper material thick strengthening degree, hardness, impact force, strength resistance, collection rate, elongation rate, so the alloy iron in the exercise of high quality iron, is an additive element.

  • Pet

  • blade

  • For example, if the barbed rope is used for circling, the cost per meter is only a few yuan. If the other products are used for circling, it may be more than ten or even 20 yuan. This is undoubtedly to increase the cost of users again, so the barbed rope is the most economical and affordable product for breeding cattle and sheep.

  • At present, there are two processing methods of blade stabbing rope. One is to make it into a spiral shape, and then make a clip treatment. It is not only our common spiral blade stabbing rope, but also a single spiral blade stabbing rope without clip, but even a single helix can not stretch it to a relatively straight. This is mainly because the blade barbed rope is wrapped and wound at the same time, so it can only be spiral.


  • Post time: 30-12-22
  • Galvanized wire according to the production technology can be divided into: hot galvanized wire, electroplating wire hot plating: 8# — 36# (3.8mm,0.19mm) electroplating: 8# — 38# (3.8mm-0.15mm)

  • To stop normalizing or soxhlet processing of wire rod, spheroidization annealing is used instead of large specification. In the middle, especially before the waste drawing process, the thermal disposal of soxhlet is widely used. Prevent decarbonization during thermal disposal. After hot disposal, sulfuric acid or hydrochloric acid pickling is used to remove the iron sheet. Coating can be used to dip lime, phosphating, borax treatment or copper plating.
  • That said, it can always deform by pulling hard without changing its integrity, so cold drawing has usually reached a limit, which is not a problem, because without this property it increases hardness, which is the desired effect. Cold wire drawing encountered more rain, when the climate is wet, easy oxidation and rust. Therefore, in the storage process should pay attention to avoid rust.


  • Post time: 26-08-22

  • Post time: 27-04-22

  • Post time: 11-08-22