Latest articles

  • Cages are more often used to contain large dogs, which have a lot of strength. So the choice of dog cage must be strong, otherwise the dog is easy to break out of the dog cage.
  • Generally larger birds choose tall but more dense cage, so as not to damage the tail feathers. Although bailing and other small body, but high flying singing habits, with a special high cage.

  • The above is to extend the service life of stainless steel barbed rope method, mainly to spray and galvanized.

  • The corrosion or discoloration of galvanized iron wire in the atmosphere caused by oxygen, moisture and other pollution impurities is called rust or rust. After galvanized iron wire rusting, it will affect the appearance quality, seriously affect the use, and even cause scrap, so galvanized iron wire must be properly kept and pay attention to rust prevention.

  • Wire mesh is the iron screen with high corrosion resistance, the same is also one of the iron net class of widely used net class, its efficient corrosion resistance function in breeding industry, construction industry and other aspects are much liked. Its smooth and neat net surface, not only increased their aesthetic feeling, but also can play a certain decoration effect.

  • The corrosion resistance of hot dip galvanized is much higher than that of cold dip galvanized, also known as electric dip galvanized. Hot wire will not rust for several years, cold galvanized will rust within three months. The cold galvanizing process is used to protect the metal from corrosion, for which the coating of zing filler is used,which is applied to the protected surface by any of the coating methods and dried to form a zinc filler coating with a zinc content (up to 95%) in THE DRY coating.

  • During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.


  • Post time: 27-04-22
  • The surface of the galvanized wire deposition layer before galvanized to remove the surface film layer, surface inclusion and other defects to the local, can be found and treated by conventional technology. Excess foam is caused by soaps and saponable fatty surfactants being brought into the tank. Moderate foam formation rates may be harmless.

  • 2, the production and installation is simple and fast, the use of patented friction connection or special connection accessories for installation, greatly improve the installation efficiency.
  • Wire diameter: 0.6 (mm)
  • Wire mesh welding after galvanized is through the end of the welding and then the cold company to make wire mesh wire mesh steel mesh construction mesh floor heating mesh galvanized or hot galvanized. After the first galvanized welding is to change the wire mesh, after the end of welding can see the welding spot; The two processes are different prices are also very different, the cost of the first plating after welding is low, the appearance is smooth, and the cost of the first welding after plating is higher, not easy to rust.


  • Post time: 09-05-22

  • Post time: 21-02-23
  • Pure zinc is more stable in dry air. In moist air or water containing carbon dioxide and oxygen, the surface will generate a layer of basic zinc carbonate based thin film layer, which can delay the corrosion rate of zinc layer. Comparison of corrosion resistance of zinc coating in aqueous solution of acid, alkali and sodium chloride; It is also resistant to corrosion in atmospheres containing carbon dioxide and hydrogen sulfide and in oceanic atmospheres; In high temperature and high humidity air and contain organic acid atmosphere is small, galvanized layer is also easy to be corroded.

  • Customers do not need to worry about the impact of the production cycle when ordering products from the thorn rope factory, because the overall treatment is now focused on the waste gas, so the production of thorn rope should be said to have the least impact. Customers ordering products in the thorn rope factory can rest assured that the delivery time this piece, can provide customers with goods on time. If the production cycle is not affected, then customers will be more assured of the thorn rope factory.

  • Hot dip galvanized wire is used in carbon structural steel, which is processed by drawing and hot dip galvanized. It is widely used in the manufacture of wire mesh, highway guardrail and construction projects. Electro galvanized wire is a kind of metal conforming material made of low carbon steel as core wire by wire drawing and electro galvanized process. Mainly used in wire mesh, highway guardrail and construction projects.

  • (2) The construction is simple and does not need special technology;
  • Now many hardware manufacturers produce iron wire, and iron wire is very easy to rust, if you need to use in outdoor or humid places, generally customers will require the use of galvanized iron wire equipment to give the wire a layer of zinc, the thickness can be determined according to user requirements. Galvanized iron wire equipment is specially used for the plating of iron. Generally speaking, the stability of zinc is much higher than that of iron, and it will not rust in the daily water vapor or damp place.


  • Post time: 30-03-23
  • The construction of inner wall and outer wall steel wire mesh can effectively solve the wall cracks, falling off, empty drum phenomenon. Hot dip galvanized steel wire mesh material requirements: net surface leveling, width and length to meet the project required standards, welding process, weight, zinc, etc., with more production and operation, detection certificate is complete.

  • 6, barbed rope protection network layout should be according to the road boundary terrain necessary renovation, flat section level set, slope section slope or step set.

  • Copper sulfate point test is a simple way to quickly distinguish ordinary carbon steel and all types of stainless steel wire rope. The concentration of copper sulfate solution used is 5%-10%. Before the point test, the experimental area should be thoroughly removed from the oil or other impurities, and a small area should be polished by grinding machine or soft grinding cloth, and then the test liquid drops to the grinding place. Ordinary carbon steel or iron in a few seconds will form a layer of outer metal copper, and the surface of stainless steel does not produce copper precipitation or display copper color.

  •  

  • Because the size of the plane or the surface of the urban area is relatively small, many sports arenas are built in the more prosperous and lively sections, with hexagonal nets to protect the barrier, so it greatly reduces the spherical three-dimensional flying out of the field so affect the traffic order of the bad things.


  • Post time: 27-12-22
  • Second, composition. Model 201 is composed of 17Cr-4.5Ni-6Mn-N, which is a substitute steel for type 301 steel. Anping wire rolling cage is magnetic after cold working, used in railway cars. 304 composition of 18Cr-9Ni, is the most widely used stainless steel, heat resistant steel. Used for food production equipment, Xitong chemical equipment, nuclear energy, etc.
  • galvanized

  • The number of each bundle of the blade barbed rope is 50, which is reduced by hydraulic compression and thus more convenient for loading and unloading. The forklift can load and unload easily. Under normal circumstances, when the export will be packaged and sold, so that the volume occupied in the container is relatively small, it can be easily placed and will not take up much space.

  • Wire mesh welding after galvanized is through the end of the welding and then the cold company to make wire mesh wire mesh steel mesh construction mesh floor heating mesh galvanized or hot galvanized. After the first galvanized welding is to change the wire mesh, after the end of welding can see the welding spot; The two processes are different prices are also very different, the cost of the first plating after welding is low, the appearance is smooth, and the cost of the first welding after plating is higher, not easy to rust.


  • Post time: 04-11-22
  • Nemesis roller cage is used for the isolation and protection of pasture distance, railway and highway, as well as the enclosure and protection of garden apartment, government units, guard posts and border defense. The Nestor rolling cage is fixed with Nestor connecting card at intervals of 120° after the blade barbed rope is wound around the cage. After opening, the Nestor connecting card is formed into a snake belly network. After closing, the diameter of the blade barbed rope ring is 50cm.

  • Before wall plastering, the wall column is connected to the gap construction wire mesh, which can play a certain strengthening and heat preservation effect. The mesh is hung on the interface surface of different grassroots, and the length of each side should meet the requirements of 100mm, so as to prevent shrinkage and cracking caused by different grassroots. Mesh wire diameter can also determine the effect and efficiency of construction, mesh fine laid up convenient soft, high construction efficiency; Of national standard can assure quality, but laid respect is inferior to fine construction fast.

  • When using these two products, it is obvious that there is a gap between them. By pulling or bending the wire, it is often difficult to restore the original, for example, if the same place is repeatedly bent, it will be found that it has broken, and the cold drawing wire will not. Cold drawing wire compared with iron wire, its hardness, tensile resistance, bending ability is greatly enhanced, suitable for building materials.