Current location:seal oven >>Text

seal oven

Hebei Qiuzhuo door bottom noise seal59856People have read

Introduction...


  • Galvanized

  • 1. Eliminate caked zinc residue on zinc liquid surface

  • The installation mode of blade barbed rope consists of welded steel mesh and blade gill mesh. Galvanized bayonet rope, barbed wire, snake belly knife bayonet rope, flat bayonet bayonet, bayonet bayonet fence and other new protective net products. One of them. Spiral blade rope, also known as snake mesh, is divided into single ring blade rope and spiral cross blade rope two kinds. Single edge barbed wire without barbed wire, also known as barbed wire, is a new type of barbed wire, is a new type of protective net.
  • Plastic spraying is also known as electrostatic powder spraying. It is the use of electrostatic attack device to make plastic powder charged, adsorbed on the surface of the iron plate, and then through the baking of 180~220℃, so that the powder can be melted and adhered to the metal surface. Plastic spraying products are mostly used in the indoor box, and the paint film appears flat or matte. Spray powder mainly acrylic powder, polyester powder and so on.

  • Post time: 18-10-22

  • Post time: 24-04-23

  • Post time: 17-08-22
  • Cages are more often used for large dogs, which have a lot of strength. The crate must be strong, or the dog will easily break out of the crate.
  • The blade gill net of plastic paint is formed after rust protection processing after the manufacture of blade type barbed iron wire rope. The periphery of blade gill net should have good rust prevention effect, the peripheral processing should be beautiful, and can be of good practical value, more convenient installation, higher cost performance and other advantages. Plastic paint is a common electrostatic coating method, which can be fixed on the periphery of chicken wire or wire plate. After two hundred heat treatment, plastic paint or powder paint is glued to the surface of wire plate. These blade gill nets coated with plastic paint are generally used on indoor boxes. The coating processing does not take too long, mainly because the effect of rust prevention and corrosion protection is quite good, much better than the general material.

  • If adult dogs and puppies touch noses out of love, then adult dog nose touching is more meaningful. For example, dogs can touch their noses to communicate where food is safe and whether people or other animals are in danger.
  • dog

  • Post-plating treatment (passivation, hot melting, sealing and hydrogen removal, etc.) for the purpose of enhancing protective properties, decoration and other special purposes. After galvanized, chromate passivation or other conversion treatment is generally required to form the corresponding type of conversion film, which is one of the key processes to ensure the quality of post-plating.
  • Galvanized wire is processed from low carbon steel wire rod, after drawing forming, pickling rust removal, high temperature annealing, cooling and other processes. Galvanized wire is widely used. Electroplating temperature should be controlled at 30 to 50℃. Because the chloride ions in the bath are very corrosive, quartz glass heaters are generally used.

  • Welding net material has black wire, galvanized wire, wire drawing. Mesh has 1 inch, 2/1 inch, 3/1 inch, 4/1 inch, 4/3 inch, 8/5 inch, etc. Different materials, different mesh, used in different places. Therefore, welding net is an indispensable building material in construction industry.

  • Since nose touching is an important part of a dog’s social behavior, humans can use this to train them. Experts say that if owners touch their dogs’ noses regularly when they are young, they will have softer personalities and be less likely to hurt.

  • (3) For some use of special paint spraying should be baked, of course, depending on the size of the area, small can be placed in the oven, large can only be dried first, and then to dry parts for processing, lock baking, if other circumstances can only use high temperature tools bit by bit baking. The products that can be baked in the oven should be leveled at room temperature for 15 to 30 minutes, baked at a low temperature of 60 degrees Celsius for half an hour, and then baked at the reserved baking temperature for one and a half hours, and then cooled down.

  • The electrolytic deposition of large roll galvanized wire zinc-chin layer is basically the following two kinds of electrolyte: zinc is mainly in the form of zinc cation hydration in the solution; Zinc is mainly present in solution as complex anion. Acid electrolyte belongs to one class, complex cyanide and zincate electrolyte, and nickel sulfate electrolyte constitute the second class. Cyanide electrolyte and acid electrolyte are of great significance.

  • 6. Find a warm place until its fur is completely dry.

  • Now, hexagonal wire netting is widely used in Bridges, bridge piers and bridge bracket slope protection, cant bridge bracket, there are many people according to the gradient of slope to choose the right hexagonal wire netting, in gentle slope, people usually use bing slope protection system, and in the case of steep slopes, people will use the guest network gravity walls.

  • 1. Pickling treatment: the steel wire is soaked in an acidic solution to remove the oil stains and oxidation layers on the surface to ensure the adhesion of the zinc layer.

  • Post time: 01-11-22
  • Now most people buy barbed rope choose blade barbed rope, why is this? From the material blade barbed wire technology blade gill net is made of hot-dip galvanized steel plate or stainless steel sheet stamped out sharp knife sheet, high tension galvanized steel wire or blade barbed wire stainless steel wire as core wire combination of the resistance device. Because the gill net shape is not easy to contact, so it can achieve excellent protective barrier effect. The primary raw materials of products are galvanized sheet and stainless steel plate.

  • Decorative hook mesh solder joint welding, generally more robust, but assuming that workers are new, scheduling machine skills are not high, will present the situation of opening solder joints. Once this situation appears, it will bring heavy losses to customers and factories.

  • Pay attention to safety in line collection and operation, others without the consent of the monitor, Ben have to get on the bus operation. The reels should be placed lightly, stacked firmly and neatly, not more than 5 reels. Direct contact with acid and alkali must be prohibited. When the acid fog exceeds the specified target of the state, measures should be taken to control it in time, otherwise production is not allowed.

  • galvanized


  • Post time: 10-03-23

  • Post time: 28-06-22

  • Post time: 02-09-22
  • galvanized