Popular articles


  • Post time: 25-08-22

  • Post time: 27-10-22
  • Pet

  • No less than 5 disks should be extracted from each inspection lot for diameter error inspection. 1 point of steel wire should be extracted from each disk to measure steel wire diameter, and the actual diameter of steel wire at this point should be taken as the average value of the two vertical directions. The diameter error of cold-drawn low carbon steel wire should conform to the rules in the table below. The unqualified inspection batches shall be checked one by one, and the qualified batches can be used for engineering.

  • Large hexagonal net called stone cage net, mainly used for mountain preparedness protection, hydraulic construction, etc. Small wire hexagonal net is used as a good material for culture, will twist the hexagonal net in the welding of the iron frame on the hexagonal net welding into chicken cage, pigeon cage, rabbit cage and other cage, hexagonal net is an excellent material for culture with net.
  • We often choose what kind of barbed rope instead of the type of barbed rope. In fact, the type of barbed rope is as important as the type of barbed rope. Let’s talk about the difference between 304 and 201 of the barbed wire rolling cage.

  • (2) Electric galvanized shaft wire direct selling shall not be used as waist hoop down reinforcement, usually not used as all binding.

  • Post time: 29-09-22
  • The use of bundled galvanized wire with the development of industry and agriculture also expanded accordingly. Therefore, galvanized wire products in the industry, such as chemical equipment, oil processing, Marine exploration, transport, electricity, shipbuilding, metal structure, etc.), agriculture (such as sprinkler irrigation, dim room, building (such as water and gas transport, wire casing, scaffolding, house, etc.), Bridges, shipping, etc., has been widely use in recent years. Because galvanized wire goods have beautiful surface, good corrosion resistance and other characteristics, its use scale is more and more extensive.

  • galvanized

  • The surface of the galvanized wire deposition layer before galvanized to remove the surface film layer, surface inclusion and other defects to the local, can be found and treated by conventional technology. Excess foam is caused by soaps and saponable fatty surfactants being brought into the tank. Moderate foam formation rates may be harmless.


  • Post time: 23-05-23
  • Electrically

  • blade

  • There are many kinds of specifications for crack resistant welding mesh used in the construction industry. The commonly used specifications are as follows:

  • The large roll of galvanized wire is violently extinguished in oxygen and sparks radiate, while the sodium block and magnesium bar are extinguished in oxygen and no sparks radiate. This phenomenon is determined by the composition of large rolls of galvanized wire. The large rolls of galvanized wire used in the experiment are pig iron or steel wire, both of which are alloys of iron and carbon (complex substances containing the elements iron and carbon). When the carbon in galvanized wire is extinguished, carbon dioxide will be produced, and the solid will be changed into a gas, and the volume will shrink rapidly.

  • The precautions of galvanizing wire in galvanizing are introduced in detail! When galvanized wire is galvanized, it is generally necessary to pay attention to the following problems: the duration of the protective effect of galvanized wire is greatly related to the thickness of the coating. Generally speaking, in the dry main gas and in indoor use, the thickness of galvanized wire galvanized layer only 6-12 μm “, and in harsh environmental conditions, galvanized wire galvanized layer thickness needs 20μm “to B height up to 50μm”. Therefore, the environmental impact should be considered when choosing the thickness of galvanized layer. Galvanized wire in galvanized, pay attention to the above problems, can be well galvanized, to ensure the quality of galvanized wire.

  • Non-proportional extension strength: It is mainly for hard steel without yield point. It is defined as the stress where the residual elongation of the standard distance part reaches 0.2% of the length of the original standard distance.
  • Before wall plastering, the wall column is connected to the gap construction wire mesh, which can play a certain strengthening and heat preservation effect. The mesh is hung on the interface surface of different grassroots, and the length of each side should meet the requirements of 100mm, so as to prevent shrinkage and cracking caused by different grassroots. Mesh wire diameter can also determine the effect and efficiency of construction, mesh fine laid up convenient soft, high construction efficiency; Of national standard can assure quality, but laid respect is inferior to fine construction fast.


  • Post time: 09-05-22
  • dog

  •  

  • Titanium and titanium alloy with light weight, high strength, corrosion resistance and many other characteristics, titanium and its alloy not only in aviation, aerospace industry has a very important application, and has begun to chemical, petroleum, light industry, power generation, metallurgy and many other civil industrial sectors are widely used. However, titanium and titanium alloy are smaller than steel in terms of hardness and strength. The shortcomings of titanium alloy wire made of titanium alloy in terms of hardness limit its breadth and depth of application.


  • Post time: 28-07-22

  • Post time: 01-09-22