stair edge guard

The block is unlikely to distort except after severe overheating, but check anyway using a steel ruler or similar high-quality straight-edge.

Detergents: This additive isn’t like your laundry detergent! It focuses on preventing deposits, rust, and corrosion from forming on the piston ring area, piston under-crown, and other surfaces that tend to overheat.

Table 4: JTEKT oil seal type codes and corresponding ISO and JIS standards

ERIKS type M (type B according to the DIN standard) has a single metal casing and rubber sealing lip. Since the casing is made of metal, it must be fitted in a well-finished, undamaged groove. Large volumes of oil seals with metal casings are often cheaper, which is why they are often used as original equipment in machines. However, if an oil seal has to be replaced, types with a rubber exterior (type R or RST) are easier to fit. Type MST is similar to M and commonly used. The difference is the dust lip in the MST oil seal that prevents dust and dirt reaching the sealing lip, and extends its service life in dusty environments.

Helix Seal

In this kind of seal, wider tolerances are possible between the OD of the seal and the seal housing. Irregularities of the housing surface can be taken up by the resilient rubber layer on the outside of the seal. However, the rubber covered seal can be blown out under high pressure in a reciprocating application whereas, with a metal case, there is no such danger.

 
3. Shaft and housing design

Oil seals in any size, material or quantity

The depth of the bonded seal can be less and the space between the bore and the outside diameter can be changed for ease of fitting. The bonding of rubber to metal is an important factor to be considered in the manufacture of such seals and should be considered carefully, since failure of the bond will cause the seal to fail. The metal case of the oil seal is usually made from mild steel of deep drawing quality which enables blanking, punching, stamping of the steel to the required dimensions.