The head gasket and valve cover gasket are critical components in the engine's sealing system. The head gasket seals the cylinder head to the engine block, while the valve cover gasket seals the valve cover to the cylinder head. Both gaskets play pivotal roles in maintaining the integrity and functionality of the engine, preventing oil leaks and ensuring the proper sealing of the combustion chamber.

These seals are designed to fit snugly around the shaft of the machine, preventing oil from leaking out while also keeping dirt, dust, and other contaminants from entering.

They are best known for their bright light emission that is far reaching. Their tungsten is encased in a quartz tube filled with xenon gas. They may require more power when turned on but use much less of it to maintain brightness. Moreover, they have a longer lifespan compared to the halogens. They may seem better but they also present some limitations such as being more expensive as far as manufacturing and replacement is concerned. They are not easy to manufacture from their complex design. Their bright light cause a blinding effect to oncoming traffic which is undesirable and can cause dangers on roads.

It is quite common for a groove to develop at the sealing lip at some point due to long-term use. As a result, the new oil seal no longer fits and seals properly. It is not strictly necessary to replace or repair the entire shaft. Take a closer look at the dimensions first. It may be possible to fit with a slightly narrower or wider oil seal next to the groove. Alternatively, using the Speedi-Sleeve repair kit, repair the running surface under the seal.

Pick the proper seal for your bearing with the NBC bearing.

Proper installation of the 25x47x7 oil seal is essential to ensure its effectiveness. It is important to carefully clean and prepare the surfaces where the seal will be placed, as any dirt or debris can compromise the seal's ability to function properly. Additionally, the seal should be installed with the correct orientation and pressure to create a tight and secure seal.

Types of oil seals

The edge of the metal is finely ground after seal manufacture in a centerless grinder to enable an interference fit in the oil seal housing. A slight chamfer on the outer diameter (OD) of the seal is desirable for easy assembly. The sealing lip is prepared by buffing, grinding or cutting away the rubber flash which occurs at the sealing edge. A fine sealing edge creates sufficient pressure on the shaft to minimise spring load, leading to lower friction whilst maintaining effective seal performance. The garter spring plays an important role in the efficiency of the oil seal. If its tension is too high, heat will be generated between the sealing lip and the shaft, and result in rapid wear of the lip. If too low, the spring will be ineffective and the sealing lip will be worn away leading to leakage of the fluid.

ERIKS type M (type B according to the DIN standard) has a single metal casing and rubber sealing lip. Since the casing is made of metal, it must be fitted in a well-finished, undamaged groove. Large volumes of oil seals with metal casings are often cheaper, which is why they are often used as original equipment in machines. However, if an oil seal has to be replaced, types with a rubber exterior (type R or RST) are easier to fit. Type MST is similar to M and commonly used. The difference is the dust lip in the MST oil seal that prevents dust and dirt reaching the sealing lip, and extends its service life in dusty environments.

JTEKT

Carboxylate Nitrile