Links

  • Stainless steel barbed rope service life is, of course, the longer the better. But do you know how to extend the service life of stainless steel barbed rope?

  • The surface of alluvium before hot dip galvanizing of orchard special electric galvanized shaft wire can partially remove the surface film layer, surface impurity and other shortcomings according to the basic technology to find and solve; Excessive foam is caused by soap and soapable surface active substances such as human fat into the tank. A moderate rate of foam production would be fine. There are many fine homogeneous particles in the tank, can stabilize the foam layer, with activated carbon mat to remove surface active substances. Or make the bubble unstable according to overworry, these are all reasonable countermeasures; Other strategies should also be used to reduce the amount of surface-active substances introduced. The introduction of organic matter can make the electroplating process speed drop sharply. Although the secret recipe of organic chemistry is beneficial to the high accumulation rate, the thickness of the coating can not meet the requirements after the organic matter is brought in, so the activated carbon can be used to solve the tank.

  • The main raw material of blade barbed rope is galvanized wire and galvanized sheet, because the price of galvanized sheet is more expensive than galvanized wire, so it is directly reflected in the price of the sales of blade barbed rope. There is also the difference in processing technology also led to the difference in the price of the blade thorn rope. The traditional barbed rope is mechanically twisted, which uses less labor and has high production efficiency. But the blade is after two mechanical processing in the manual processing operation before the appearance. So whether from the labor force or from the production efficiency also said there is a large gap. These factors lead to the price of blade thorn rope is more expensive the main factor.

  • The temperature of large roll galvanized wire should be controlled at 30 to 50℃ during electroplating. Because the chloride ions in the bath are very corrosive, quartz glass heaters are generally used. Continuous production does not need heating, but needs cooling. Cooling can be in the groove side row thin wall plastic pipe, through the flow of tap water cooling, can also be used as a titanium pipe temperature control device.

  • B. When the thickness of the plating is greater than 4 mm, the zinc adhesion should not be less than 610g/m, that is, the average thickness of the zinc layer should not be less than 86 microns.
  • hexagonal


  • Post time: 01-07-22

  • Post time: 10-11-22
  • PVC


  • Post time: 02-03-23
  • At present, there are two processing methods of blade stabbing rope. One is to make it into a spiral shape, and then make a clip treatment. It is not only our common spiral blade stabbing rope, but also a single spiral blade stabbing rope without clip, but even a single helix can not stretch it to a relatively straight. This is mainly because the blade barbed rope is wrapped and wound at the same time, so it can only be spiral.